This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
troubleshooting [2016/01/02 19:52] dos [rad1o usb disconnects every 5 seconds / not usable at all] add rad1o USB PID aside of HackRF one |
troubleshooting [2016/12/27 00:26] (current) 151.217.239.253 [I've connected the rad1o in Mass Storage Mode, but the filesystem is read only] |
||
---|---|---|---|
Line 45: | Line 45: | ||
| | ||
- run fsck on that partition | - run fsck on that partition | ||
- | fschk.vfat -v /dev/sdb | + | fsck.vfat -v /dev/sdb |
| | ||
- follow the instructions of fsck | - follow the instructions of fsck | ||
Line 140: | Line 140: | ||
===== display blinks if turned on, but quickly turns off afterwards. All fine on USB power ===== | ===== display blinks if turned on, but quickly turns off afterwards. All fine on USB power ===== | ||
- | Your battery is empty. The voltage might be even too low to be recharged. | + | Your battery is empty. |
- | Try to kickstart the loading process by connecting the read and black cables of the battery to a 3.7V source for about a minute. | + | |
- | Or if you have professional LiPo-charger complaining about voltage being too low, try NiMh mode, until you reach about 3.4V. Then continue loading normally or via a USB. | + | |
- | BE CAREFUL and ask an experienced friend to help you. | + | |
===== on/off switch is not working anymore ===== | ===== on/off switch is not working anymore ===== |