User Tools

Site Tools


leds

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
leds [2015/12/20 23:04]
schneider [How to properly solder the LED's]
leds [2015/12/20 23:07]
schneider [RGB LEDs]
Line 25: Line 25:
  
 Example with all possible LEDs and correct bridges on two of the three transistor pins (for power supply) soldered (LEDs green, bridges red): Example with all possible LEDs and correct bridges on two of the three transistor pins (for power supply) soldered (LEDs green, bridges red):
-{{ :led3.png?100 |}}+{{ :led3.png?600 |}}
  
 Example with only two LEDs at the antenna, then the bridges at the lower part of the board aren't needed but you need to add bridges for transporting the signal (ignore the yellow arrows): https://​twitter.com/​michaelossmann/​status/​629779084801781760 Example with only two LEDs at the antenna, then the bridges at the lower part of the board aren't needed but you need to add bridges for transporting the signal (ignore the yellow arrows): https://​twitter.com/​michaelossmann/​status/​629779084801781760
Line 53: Line 53:
 The 2 lower LEDs should be yellow, the one at the tip of the antenna should be green and the other 5 LEDs on the antenna blue. The 2 lower LEDs should be yellow, the one at the tip of the antenna should be green and the other 5 LEDs on the antenna blue.
  
-== The Hard Way ==+===== The Hard Way =====
 Have a look at [[leds-the-hard-way|How to properly solder the LED'​s]] to see how to get a bit more brightness out of your LEDs. Have a look at [[leds-the-hard-way|How to properly solder the LED'​s]] to see how to get a bit more brightness out of your LEDs.
leds.txt ยท Last modified: 2015/12/20 23:10 by schneider