This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
hardware [2015/08/12 15:21] longneck [Overview] |
hardware [2015/08/23 13:24] (current) riot knubbel++ |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | = Overview | + | = rad1o |
- | {{ :rad1o_highlighted.png?500 |}} | + | * [[hardware:overview|rad1o hardware overview]] |
- | + | * [[more_hardware|More about the hardware]] | |
- | a) No antenna, only deco, pads for additional RGB LEDs (see [[leds|RGB LEDs]])\\ | + | |
- | b) more pads for RGB LEDs (in total there are 3 RGB LED areas, on the part that looks like an antenna, and in the lower left and right area of the board) (see [[leds|RGB LEDs]])\\ | + | |
- | c) **On/Off-Switch**\\ | + | |
- | d) **Micro-USB for connecting to laptop**\\ | + | |
- | e) Micro-USB for additional energy\\ | + | |
- | f) external clock out, an SMA connector (X201) could be soldered here (not for antennas!)\\ | + | |
- | g) clock generator\\ | + | |
- | h) on-board PCB antenna\\ | + | |
- | i) pads for SMA connector (X301) or external antenna. Any edge-launch SMA socket for 1.6mm PCB thickness should work. (see [[antennas|Antennas]])\\ | + | |
- | j) radio frequency part, for sophisticated applications you may want to cover this with a metallic shield to prevent irradiations\\ | + | |
Line 22: | Line 12: | ||
see [[leds|LEDs]] | see [[leds|LEDs]] | ||
+ | = Joystick | ||
- | = More details about the board | + | There is a printable Joystick [[http://www.thingiverse.com/thing:970761|knob]] from spezi. |
- | + | ||
- | see [[more_hardware|More about the hardware]] | + |