User Tools

Site Tools


hardware

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
hardware [2015/08/13 23:33]
lilafisch [Overview] adding an SMA connector needs some caution
hardware [2015/08/23 13:24]
riot knubbel++
Line 1: Line 1:
-Overview +rad1o 
-{{ :​rad1o_highlighted.png?​500 |}} +  ​* ​[[hardware:​overview|rad1o hardware overview]] 
- +  * [[more_hardware|More about the hardware]]
-a) No antenna, only deco, pads for additional RGB LEDs (see [[leds|RGB LEDs]])\\ +
-b) more pads for RGB LEDs (in total there are 3 RGB LED areas, on the part that looks like an antenna, and in the lower left and right area of the board) (see [[leds|RGB LEDs]])\\ +
-c) **On/​Off-Switch**\\ +
-d) **Micro-USB for connecting to laptop**\\ +
-e) Micro-USB for additional energy\\ +
-f) external clock out, an SMA connector (X201) could be soldered here (not for antennas!)\\ +
-g) clock generator\\ +
-h) on-board PCB antenna\\ +
-i) pads for SMA connector (X301) or external antenna. Any edge-launch SMA socket for 1.6mm PCB thickness should work. (see [[antennas|Antennas]], note the warnings for soldering!)\\ +
-j) radio frequency part, for sophisticated applications you may want to cover this with a metallic shield to prevent irradiations\\+
  
  
Line 22: Line 12:
 see [[leds|LEDs]] see [[leds|LEDs]]
  
 += Joystick
  
-= More details about the board +There is a printable Joystick ​[[http://​www.thingiverse.com/​thing:​970761|knob]] from spezi.
- +
-see [[more_hardware|More about the hardware]] +
hardware.txt · Last modified: 2015/08/23 13:24 by riot