rad1o

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== rad1o hardware overview ======
{{ :rad1o_highlighted.png?500 |}}

a) No antenna, only deco, pads for additional RGB LEDs (see [[:leds|RGB LEDs]])\\
b) more pads for RGB LEDs (in total there are 3 RGB LED areas, on the part that looks like an antenna, and in the lower left and right area of the board) (see [[:leds|RGB LEDs]])\\
c) **On/Off-Switch**\\
d) **Micro-USB for connecting to laptop**\\
e) Micro-USB for additional energy\\
f) external clock out, an SMA connector (X201) could be soldered here (not for antennas!)\\
g) clock generator\\
h) on-board PCB antenna\\
i) pads for SMA connector (X301) or external antenna. Any edge-launch SMA socket for 1.6mm PCB thickness should work. (see [[:antennas|Antennas]], note the warnings for soldering!)\\
j) radio frequency part, for sophisticated applications you may want to cover this with a metallic shielding to prevent irradiations\\


{{ :rad1o_6.jpg?425}}

The rad1o badge contains a full-featured SDR (software defined radio) half-duplex transceiver, operating in a **frequency range of about 50 MHz - 4000 MHz**, and is software compatible to the [[https://greatscottgadgets.com/hackrf/|HackRF]].

It is based on a Wimax transceiver which sends I/Q samples in the range of 2.3 to 2.7 GHz to an ARM Cortex M4 CPU. The CPU can **process the data standalone** for various applications (like FM receiving, spectrogram display, RF controlled power outlets, etc.), **or pass the samples to a computer** using USB 2.0 where further signal processing can be done e.g. using [[http://gnuradio.org/|GNU Radio]]. Radio signal transmission is also possible in standalone mode by software running on the ARM CPU, or from samples that are sent to rad1o through USB.

The extended frequency range is enabled by a mixer that can be inserted into the RF path. For immediate usage, the board contains a **2.5 GHz PCB antenna**. Alternatively, an external antenna can be attached to an SMA connector which can be easily soldered onto the badge by yourself.

The rad1o also provides a Nokia 6100 **130x130 pixel LCD** and a **joystick** already known from the [[http://r0ket.de|r0ket]] from the last CCCamp 2011.
  
We also included a 4-pin 3.5 mm **audio connector** which allows both (mono) headphone and microphone operation with a standard headset.
  
There are two micro USB ports, both can charge the battery. USB0 can be used for software updates and data I/O to SDR software like GnuRadio.
rad1o

User Tools

Site Tools

Page Tools
