This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
case [2015/07/14 09:47] mkie |
case [2015/08/14 23:21] 151.217.236.138 [Limited case run on Camp] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | == CAD Data for a rad1o case | + | = Limited case run on Camp |
+ | |||
+ | **syso** will be only there at saturday and sunday, but he will be bringing (High-Resolution, pretty) Laser Cut Enclosures (different styles) to the Camp. If you want to get one, please send an e-mail to cccamp-rad1o-cases (at) ext.no-route.org | ||
+ | |||
+ | Note: this is not an official rad1o enclosure. syso is just volunteering to provide them. | ||
+ | |||
+ | = CAD Data for a rad1o case | ||
If you want to build your own case for the rad1o, we added DXF files to github. | If you want to build your own case for the rad1o, we added DXF files to github. | ||
Line 12: | Line 18: | ||
You can also easily make your own dxf files using Eagle, just activate your desired layers and run the dxf.ulp | You can also easily make your own dxf files using Eagle, just activate your desired layers and run the dxf.ulp | ||
+ | |||
+ | == Height of the case | ||
There were some questions about the height, normally there are no parts on the backside, only if you need JTAG connections or a few CPLD extension lines connects here. If you solder the SMA connectors, you need about 1,5 mm here. | There were some questions about the height, normally there are no parts on the backside, only if you need JTAG connections or a few CPLD extension lines connects here. If you solder the SMA connectors, you need about 1,5 mm here. | ||
Line 20: | Line 28: | ||
Happy building or knitting! | Happy building or knitting! | ||
+ | |||
+ | = Simple laser-cut case | ||
+ | |||
+ | [[https://github.com/rad1o/hardware/tree/master/cases/01_simple_lasercut|Here]] you can find a simple design for a laser-cut case. | ||
+ | You can use acrylic glass or even wood for this. It offers basic protection and some mounting for a lanyard or clip. | ||
+ | Feel free to add custom engraving to find your rad1o again when giving it out of hand. | ||
+ | Parts needed: | ||
+ | * 2pcs 10cm x 13cm acrylic glass/wood/.. | ||
+ | * 4pcs M3x28mm screw | ||
+ | * 8pcs M3 screw nut | ||
+ | * 8pcs M3 nylon screw nut (or any other isolating material - alternatively, isolating washers) | ||
+ | |||
+ | {{:cases:simple_laser_cut_top.jpg?200 |}} | ||
+ | |||
+ | {{:cases:simple_laser_cut_bottom.jpg?200 |}} | ||